aggregate ceramic replacement in concrete

Mechanical Properties of Concrete with Ceramic Waste …

On the addition of ceramic powder as replacement for fine aggregate in concrete, performance under compressive loading was comparable to that of concrete prepared using river sand as fine aggregate (Lopez et al., 2007). Compressive strength and flexural strength of concrete prepared using ceramic waste aggregate as replacement for et al. (2008 ...

Contact us

Experimental Analysis on Concrete by Partial Replacement ...

concrete as a replacement for fine aggregate which is getting costlier nowadays. Ceramic tile waste is found as an effective alternate and supplementary material in concrete with the optimum replacement of 40%. (Hitesh Kumar, et al., Aug 2015) [8].The optimum percentage of concrete with ceramic tile waste for coarse and fine

Contact us

Utilization of Crushed Ceramic Tile Wastes as Partial ...

aggregate by partial replacement of coarse aggregate. Ceramic waste could be transformed into useful coarse aggregate. The aim of this study was to produce and test M20 quality concrete with ceramic tile waste. The compressive and flexural strength results of the concretes will be determined by curing 7 and 28 days. The aim of this

Contact us

Compressive strength and durability properties of ceramic ...

30 MPa were prepared with 20% cement replacement by ceramic powder (W/B = 0.6). A concrete mix with ceramic sand and granite aggregates were also prepared as well as a concrete mix with natural sand and coarse ceramic aggregates (W/B = 0.5). The mechanical and durability performance of ceramic waste based concrete are assessed by means of

Contact us

VALLUR,PRAKASAM(Dt).

powder are used as a replacement to the coarse aggregates and fine aggregate. The ceramicwaste crushed tiles were partially replaced in place of coarse aggregates by 10%, 20%, 30%, 40% and 50%.Granite powder and ceramic tile powder were replaced in place of fine aggregate by 10% along with the ceramic coarse tile. M25

Contact us

Replacement of stone Dust and Ceramic scrap as Aggregate ...

ceramic waste aggregate increases. Compressive strength of concrete made using 05 % ceramic waste aggregate and 05 % stone dust as replacement of coarse aggregate and fine aggregate respectively, is about 20% more than that of referral concrete at 28 days.

Contact us

Materials 14 02917 | Concrete | Cement

materials. Article Clay Ceramic Waste as Pozzolan Constituent in Cement for Structural Concrete Everton dos Santos Barreto 1, Karina Vaz Stafanato 2, Markssuel Teixeira Marvila 1, Afonso Rangel Garcez de Azevedo 3, *, Mujahid Ali 4, Ronald Matheus Lobo Pereira 5 and Sérgio Neves Monteiro 1,5. 1 LAMAV-Advanced Materials Laboratory, UENF-State University of the Northern Rio de Janeiro,

Contact us

how to cast concrete tiles in coarse sand

and broken waste ceramic tiles for replacement at coarse aggregate in the production of concrete mixture. OBJECTIVE x To study the characteristi c strength of concrete with 10%, 20%, 30% and 40% of coarse and fine aggregates with sawdust and broken ceramic tiles. x To reduce the cost per m3 of concrete.

Contact us

EXPERIMENTAL STUDY ON CONCRETE BY PARTIAL …

ceramic tile waste as partial coarse aggregates replacement towards compressive strength of concrete. viii) To determine the water absorption of ceramic aggregate concrete containing various content of ceramic tile as partial coarse aggregates replacement material. ix) To find the optimum proportion (10%, 20% &

Contact us

The Use of Ceramic Tile Waste as Aggregate in Concrete

aggregate with replacement levels of 10%, 20%, 30%, 40%, and 50%. Besides, five mixes incorporated fine crushed ceramic as partial substitute of fine aggregate with replacement levels of 20%, 40%, 60%, 80%, and . Slump test was conducted to investigate the effect of incorporating ceramic aggregates on the workability of fresh concrete.

Contact us

Ceramic tiles waste as coarse aggregates partial ...

In accordance with conservation efforts, this research focuses on ceramic tile waste as partial coarse aggregates replacement for concrete production, prevention of environmental pollution with considering the elements of sustainable and cost-saving construction projects, especially material usage. Moreover, many of the construction industry in Malaysia produce construction waste that ...

Contact us

Utilization Of Waste Ceramic Tiles As Coarse Aggregate In ...

absorption and modulus of elasticity of concrete made with ceramic aggregate. Crushed ceramic blocks were used as coarse aggregate in concrete fabrication. Specific density of aggregate was 2630 to 2310 kg/m3 for 0 to replacement. Up to the replacement of …

Contact us

Durability of Concrete with Ceramic Waste as Fine ...

While using ceramic tiles as partial replacement of fine aggregate, workability decreased with increase in replacement level. It is observed that, compressive strength of concrete made using ceramic waste increased with replacement level (up to 40%). Optimum replacement level of fine aggregate with

Contact us

(PDF) " PARTIAL REPLACEMENT OF AGGREGATE WITH CERAMIC …

(PDF) " PARTIAL REPLACEMENT OF AGGREGATE WITH CERAMIC TIL…

Contact us

Carbonation Depth of Recycled Aggregate Concrete ...

This paper addresses the efficiency of using recycled concrete as an aggregate by systematically presenting results on the influence of fly ash on recycled aggregate concrete (RAC) properties. The percentage of recycled aggregate replacements of natural aggregate used by weight was 50%. Fly ash (FA) was used as 0, 10, 20, 30, and 40% by weight replacement of cement.

Contact us

FLEXURAL BEHAVIOR OF CONCRETE BEAMS CONTAINING …

and reinforced concrete beams with ceramic waste as replacement of coarse aggregate. A total of forty-five (45) non-reinforced beams (150x150x750mm) and ten (10) reinforced beams (150x250x2150mm) were used to investigate the flexural behavior of the specimens. The flexural parameters investigated are crack formation and pattern, failure mode,

Contact us

THE USE OF CERAMIC TILES WASTE IN CONCRETE AS PARTIAL ...

with a replacement of fine aggregates up to 20 % of demolition waste and 20 % ceramic wastes in concrete [5]. The utilization of crushed tile as coarse aggregates in replacement of natural coarse aggregates in concrete established that the maximum compression strength and split tensile strength were obtained when the replacement was at 30% [6].

Contact us

Partial Replacement of Fine Aggregate & Cement in …

The optimum replacement possible for fine aggregate and cement with quartz and grog is 5%. 2. Compressive strength of concrete with optimum replacement at 7 days and 28 days of water curing is 26.14N/mm2 and 43.61 N/mm2. 3. Compressive strength of concrete with replacement of Msand by 5% quartz and 5% grog at 7 days and 28

Contact us

Partial Replacement of Coarse Aggregate with Broken ...

Partial Replacement of Coarse Aggregate with Broken Ceramic Tiles in Concrete Production Yiosese A. O., Ayoola A. R., Ugonna M. C., Adewale A. K. Abstract— The study reports on experimental investigation on the suitability of the use of broken tiles as partial replacement for crushed granite in concrete production.

Contact us

Experimental Investigation Of Using Ceramic Waste As A ...

Various other uses for lightweight aggregates are discussed that contribute to an environmentally friendly world. Keywords: Experimental, Investigation, Using Ceramic Waste, Coarse Aggregate, Light Weight Concrete 1 INTRODUCTION Lightweight aggregates can fill many roles that will make human activity more environmentally responsible.

Contact us

What are the replacement materials for coarse aggregate ...

You cant replace, coarse aggregates as the 70% of volume of concrete is madeup out of it. Coarse aggregates are particles of size more than 4.75mm and can be found in any shape like round, cubical, irregular, flaky, elongated etc. Currently in mks...

Contact us

Partial Replacement of Cement in Concrete using Ceramic ...

 · After recycling ceramic waste can be used in different construction application. Researches used ceramic waste to generate green concrete by using 20% replacement of natural aggregate. It can be shown that the concrete produce from ceramic waste is good workable and achieve characteristic strength [9, 10, 11, 12].

Contact us

Experimental Study on Partial Replacement of Coarse ...

concrete by replacing cement and coarse aggregate with glass powder and ceramic tile wastes respectively. It deals with the problem of greenhouse gas emission and avoids landfill disposal of ceramic tile wastes. 3.0 Mix Material 3.1 Ceramic Tiles A ceramic material is an inorganic, non-metallic, often crystalline oxide, nitride or carbide ...

Contact us

Partial Replacement of Coarse Aggregate by Waste Ceramic ...

DOI: 10.22214/IJRASET.2017.3086 Corpus ID: 115138061. Partial Replacement of Coarse Aggregate by Waste Ceramic Tile in Concrete @article{Sekar2017PartialRO, title={Partial Replacement of Coarse Aggregate by Waste Ceramic Tile in Concrete}, author={M. Sekar}, journal={International Journal for Research in Applied Science and Engineering Technology}, year={2017}, pages={472-479} }

Contact us

Experimental Analysis of Concrete Using Ceramic Tile ...

• In 1m³ concrete ₹523/- saved in 50% replacement of waste with fine aggregate and coarse aggregate without disturbing the required compressive strength of concrete. • Ceramic waste can effectively be used as alternative & supplementary materials in concrete.

Contact us

Partial Replacement of Aggregates with Ceramic Tiles and ...

to the coarse aggregates and fine aggregate. The ceramic waste crushed tiles were partially replaced in place of coarse aggregates by 10%, 20%, 30%, 40% and 50%. Rebutted tyre waste and ceramic tile powder were replaced in place of fine aggregate by 10% along with the ceramic coarse tile. M25 grade of concrete was designed and tested.

Contact us

Ceramic Waste : Effective Replacement Of Cement For ...

Ceramic waste can be used in concrete to improve its strength and other durability factors. Ceramic waste can be used as a partial replacement of cement or as a partial replacement of fine aggregate sand as a supplementary addition to achieve different properties of concrete.

Contact us

Experimental study on concrete using waste ceramic as ...

 · Fine aggregate was replaced with crushed ceramic waste aggregate at different percentages as follows 0, 5, 10, 15, and 20% in the concrete composition. To determine the value of Mechanical properties of fine aggregate (river sand) and fine ceramic aggregate, which is extracted from the waste ceramics, were obtained through experimentation work.

Contact us

Investigation on Fine Aggregate by Broken Tiles in Concrete

Abstract: This examination manages the effect on the concrete by the partial replacement of fine aggregate by ceramic aggregate. Studies were done on a concrete, with various replacement. The impacts of various replacements 0, 10, 20, 30&40 percent of the waste ceramic tile by weight of concrete with M-30 review.

Contact us

Characterization of ceramic waste aggregate concrete

ceramic wall and floor tiles aggregate concrete. Ceramic wastes sourced from construction and demolition wastes were separated from other debris and crushed using a quarry metal hammer. Ceramic tiles were sieved into fine and coarse aggregates in line with standards. Other materials used were gravel, river sand, cement and potable water.

Contact us